STREETEC performance air suspension combines a low stance with full everyday usability – low when parked, back to the approved ride height before you drive off. Vehicle-specific twin-tube dampers and air springs for the front and rear axle form a complete kit designed for VW Polo AW platform vehicles (MQB A0).

Twin-tube dampers tuned for everyday driving

The vehicle-specific twin-tube dampers work together with the air springs as one matched unit. Short impacts and long undulations are damped in a balanced way: the car stays settled on the motorway and easy to control on poor roads. The setup is fixed for the specific vehicle, so there is nothing for you to set.

Low when parked, compliant on the road

You adjust the ride height via air pressure while the car is stationary: aired out for a low stance, back to the approved ride height within the operating pressure stated in the parts certificate before you drive. For driveways and rough stretches the car can be raised while stationary; in that state the maximum speed is 50 km/h. Height adjustment while driving is not intended. Installation must be carried out by a specialist workshop, followed by a wheel alignment, a headlight adjustment check and the modification inspection.

Made for the VW Polo AW platform

The kit is designed for VW Polo AW platform vehicles (MQB A0) with a torsion-beam rear axle – VW Polo AW, Seat Ibiza KJ and Audi A1 GB. The vehicle list shows which vehicles are covered by the parts certificate.

Target Groups

What's Included

• 2× vehicle-specific shock absorbers Front axle
• sleeve on the front dampers for a 55 mm strut clamp (remove for 50 mm) Front axle
• 2× air springs Front axle
• 2× black braided stainless air line Front axle
• 2× vehicle-specific shock absorbers Rear axle
• 2× air springs with vehicle-specific mounts Rear axle
• 4× air fitting of your choice (6 mm, 10 mm, 1/4", 3/8")
• Parts certificate (§19.3 StVZO) Document

Choose Your Air Management

To operate the air suspension you need an air management system with compressor, tank and valve control. Choose the air fitting to match your air management kit. The parts certificate requires a pressure gauge in the driver's field of view and an acoustic warning when the pressure leaves the operating range – please keep this in mind when choosing your system. You will find an overview under air management kits.