STREETEC performance PRO air suspension is built for drivers who want a car that sits low and still corners with a firm, composed feel. Inverted monotube dampers and adjustable uniball top mounts keep the front axle on line even under high cornering loads. When parked, the car can be lowered all the way down and raised back to the approved ride height before you drive off. The complete kit includes dampers and air springs for the front and rear axle and fits the Audi A1 8X quattro.

Rigid dampers for clean turn-in

In an inverted (upside-down) damper the large outer tube sits at the top, so the damper barely flexes under side loads. The car follows your steering input without delay and stays settled through quick sequences of bends. The monotube design keeps damping consistent under load. Front and rear axle receive vehicle-specific shock absorbers matched to the air springs with their vehicle-specific mounts.

Spherical bearings instead of rubber mounts up front

At the front axle, adjustable uniball top mounts replace the factory top mounts. The spherical bearing transfers forces without the compliance of a rubber mount: steering input reaches the wheels directly.

Low when parked, raised for the driveway

You adjust the ride height via air pressure: aired out for a low stance when parked, raised for driveways and rough stretches. This kit is not approved under German road traffic regulations (StVZO) – please keep this in mind before using it on public roads. Installation should be carried out by a specialist workshop, followed by a wheel alignment and a headlight adjustment check.

Made for the Audi A1 8X quattro

The kit is designed for the Audi A1 of the 8X series with quattro drive. No parts certificate is available for this kit: the vehicles in the vehicle list are a technical fit but are not approved under German road traffic regulations (StVZO).

Target Groups

What's Included

• 2× adjustable uniball top mounts Front axle
• 2× vehicle-specific shock absorbers Front axle
• 2× air springs with vehicle-specific mounts Front axle
• 2× black braided stainless air line Front axle
• 2× vehicle-specific shock absorbers Rear axle
• 2× air springs with vehicle-specific mounts Rear axle
• 4× air fitting of your choice (6 mm, 10 mm, 1/4", 3/8")

Choose Your Air Management

To operate the air suspension you need an air management system with compressor, tank and valve control. Choose the air fitting to match your air management kit. You will find an overview under air management kits.